INSTALLATION AND CONNECTIONS
SAFETY REQUIREMENTS
Before connecting to this programmable thermostat, make sure that the load
(heater, pump, etc.) is not connected to the supply and that the load is within
the ratings shown inside the thermostat.
POSITIONING
Install the programmable thermostat away from sources of heat (heaters, direct
sunlight, kitchens) and from doors/windows, and at a height of about 1.5 m
above the floor.
CLEANING
For cleaning - use only a damp cloth.
INSTALLATION
- Press to release the small catch with the aid of a screwdriver (fig.1)
- Fix the base to the wall
- Connect the load to the terminals following the wiring diagram (fig.2)
ELECTRICAL CONNECTIONS
(fig.2)
U
=
equipment load
C
=
common terminal
NO
= normally open terminal
NC
= normally closed terminal
ATTENTION
-
Fix the base on a flat surface
-
Use only the screws provided
-
When installing do not twist the base of the thermostat
-
Do not poke the base, or insert the screws in areas not intended
-
Once mounted, to extract the thermostat, pull from the wall, using
the two the side flaps (do not twist or rotate the structure)
36
Summary of Contents for 1C Series
Page 1: ...1C 61 SLIDER CHRONOTHERMOSTAT...
Page 4: ...35...
Page 6: ...1 2 fig 1 fig 2 37...
Page 32: ...IB1C61002 07 19 Finder S p A con unico socio 10040 ALMESE TO ITALY...
