Fimap GMG PRO, Operator Interface Manual

Page: 54 / 68

ACTUATOR SETS MENU (PARAMETERS)
<Proceed as follows to display the “ACTUATOR SETS” menu:
1. Display the "MACHINE BRUSHES SETTINGS" menu - see “SETTINGS MENU” on page 9 .
2. Display the “SERVICE” menu - see “SERVICE MENU” on page 16 .
3. Display the “PARAMETERS” menu - see “PARAMETERS MENU (SERVICE)” on page 17 .
4. Using buttons (1) and (2) ( Fig.1 ) select the "ACTUATOR SETS" screen ( Fig.2 ) and press button (3) to confirm
the display ( Fig.1 ).
2
1
1
Actuator
sets...
2
-SETTINGS-
N.B.: in the parameters menu, the display is only shown in English.
The following sub-menus can be selected on the vacuum menu screen:
SQUEEGE
Used to modify the parameter relating to the standby time before the actuator moves the
squeegee to the "lifted off the floor" position while reversing - see “TRACTION REVERSE
DELAY MENU (ACTUATOR SQUEEGEE)” on page 55 .
SQUEEGEE MENU (ACTUATOR SETS)
Proceed as follows to display the “SQUEEGEE” menu:
1. Display the "MACHINE BRUSHES SETTINGS" menu - see “SETTINGS MENU” on page 9 .
2. Display the “SERVICE” menu - see “SERVICE MENU” on page 16 .
3. Display the “PARAMETERS” menu - see “PARAMETERS MENU (SERVICE)” on page 17 .
4. Display the “ACTUATOR” menu , see “ACTUATOR SETS MENU (PARAMETERS)” on page 54 .
5. Using buttons (1) and (2) (
Fig.1
) select the "ACTUATOR Squeegee" screen (
Fig.2
) and press button (3) to
confirm the display (
Fig.1
).
2
1
1
Squeegee
2
Actuator
Page 54