Fimap GMG PRO, Operator Interface Manual

Page: 55 / 68

TRACTION REVERSE DELAY MENU (ACTUATOR SQUEEGEE)
Proceed as follows to change the “TRACTION REVERSE DELAY” parameter in the brush motor menu:
1. Display the "MACHINE BRUSHES SETTINGS" menu - see “SETTINGS MENU” on page 9 .
2. Display the “SERVICE” menu - see “SERVICE MENU” on page 16 .
3. Display the “PARAMETERS” menu - see “PARAMETERS MENU (SERVICE)” on page 17 .
4. Display the “ACTUATOR” menu , see “ACTUATOR SETS MENU (PARAMETERS)” on page 54 .
5. Display the “SQUEEGEE” menu , see “SQUEEGEE MENU (ACTUATOR SETS)” on page 54 .
6. Using buttons (1) and (2) ( Fig.1 ) select the "TRACTION REVERSE DELAY" screen ( Fig.2 ).
7. As soon as the “TRACTION REVERSE DELAY” screen ( Fig.2 ) is displayed, select the delay in seconds before
the actuator brings the squeegee to the "raised from the floor" position when reverse is engaged, using buttons
(3) and (4) ( Fig.1 ).
N.B.: the selected value will be visible in the text string (5) in the lower part of the screen ( Fig.2 ).
8. Confirm the selection by pressing the button (6) ( Fig.1 ).
Actuator
Squeegee
1.0 [s]
Traction reverse delay:
min:0.0 max:10.0
2
5
2 4
1 3
6
1
N.B.: the “TRACTION REVERSE DELAY” parameter is a time interval during which the squeegee remains in
the working position before lifting off the ground when reversing.
N.B.: The “TRACTION REVERSE DELAY” parameter is expressed in seconds (s), the numerical value is
between a minimum of 0,0 and a maximum of 10, the selectable increment is one unit.
N.B.: The “TRACTION REVERSE DELAY” parameter is set in the factory to 1.0.
Page 55