VACUUM NOISE LEVEL MENU (VACUUM SWEEP MOT)
Proceed as follows to change the “VACUUM NOISE LEVEL” parameter in the water motor menu:
1.
Display the "MACHINE BRUSHES SETTINGS" menu - see
2.
Display the “SERVICE” menu - see
3.
Display the “PARAMETERS” menu - see
“PARAMETERS MENU (SERVICE)” on page 17
4.
Display the “VACUUM SETS” menu - see
“VACUUM SETS MENU (PARAMETERS)” on page 46
.
5.
Display the “SWEEP VAC. MOTOR” menu - see
“SWEEP VAC MOTOR MENU (VACUUM SETS)” on page
6.
Using buttons (1) and (2) (
Fig.1
) select the "VACUUM NOISE LEVEL" screen (
Fig.2
).
7.
As soon as the “VACUUM NOISE LEVEL” screen (
Fig.2
) is displayed, select the percentage of the absorption
voltage of the suction motors present in the vacuum system of the machine using buttons (3) and (4) (
Fig.1
).
N.B.:
the selected value will be visible in the text string (5) in the lower part of the screen (
Fig.2
).
8.
Confirm the selection by pressing the button (6) (
Fig.1
).
Vacuum
Sweep Mot
60
[%]
Vacuum noise level 1:
min:10
max:100
2
5
2
4
1
3
6
1
N.B.:
the “VACUUM NOISE LEVEL” parameters indicate the absorption voltage of the vacuum gearmotor in
the machine hopper.
N.B.:
the “VACUUM NOISE LEVEL” parameters correspond to the performance levels of the vacuum system
on the machine control display.
N.B.:
the “VACUUM NOISE LEVEL” parameters are expressed as a percentage(%) of the voltage applied to
the gearmotor in the machine hopper. The numerical value is between a minimum of 010 and a maximum of
100, and the selectable increment is one unit.
N.B.:
the “VACUUM NOISE LEVEL” parameters are set to the following numbers in the factory:
•
VACUUM NOISE LEVEL 1= 80
•
VACUUM NOISE LEVEL 2= 90
•
VACUUM NOISE LEVEL 3= 100
Page 49
