STARTING WORK
To start working, proceed as follows:
1.
Carry out all the checks listed in the chapter “PREPARING TO WORK” on page 20.
2. Sit on the driver’s seat.
3.
Insert the key (1) into the main switch on the control panel. Set the main switch to "I" by turning the key a quarter turn clockwise (
Fig.1
).
4.
Open the flow of sanitizing solution, using the knob (2) on the rear left side of the steering column (
Fig.2
).
N.B.:
Remember to open the flow of sanitizing solution filly, moving the knob (2) upwards as far as it will go.
5.
Activate the sanitizing product spray function; to do this, press the button (3) (
Fig.3
).
N.B.:
if the LED on the button (3) is on, the spraying system is active; if the LED is off, the system is deactivated.
N.B.:
if you want to deactivate the spraying system, press button (3) again.
6.
Press the drive pedal (4) to begin moving the machine (
Fig. 4
).
The machine will now begin to work with full efficiency until the battery is flat or until the sanitizing solution is used up.
N.B.:
If you the drive pedal is released during work, the machine will start to slow down and the sanitizing product pump will stop
delivering the product into the machine's water circuit. The compressor will remain in operation for a few seconds when the drive pedal is
released to allow the compressed air to expel the sanitizing product present in the machine's water circuit.
HOUR METER
The machine control panel contains the control display (
Fig.5
), which shows the total usage time via a series of numbers (5). The numbers
before the letter “h” identify the hours, while the numbers before the letter “m” identify the tenths of an hour (a tenth of an hour corresponds to
six minutes).
BATTERY CHARGE LEVEL INDICATOR
The command display is in the control panel (
Fig.5
); at the centre you can see the battery charge level.
The indicator is composed of two charge level symbols, the first represented by a graphic symbol (6), the second by a number that indicates the
charge percentage (7). The indicator is composed of 5 charge levels, each of which represents about 20% of residual charge. With a residual
charge of 20% the graphic symbol starts to flash and after a few second it will appear in larger dimensions in the middle of the screen, under
these conditions take the machine to the usual place to charge the batteries.
ADDITIONAL FUNCTIONS
REVERSE FUNCTION
This machine is equipped with electronic traction control. To reverse, proceed as follows:
1.
Engage the “REVERSE GEAR ACTIVATION/DEACTIVATION” lever (1) underneath the steering wheel (
Fig.1
).
2.
Press the drive pedal (2) (
Fig.2
); in this manner the machine will begin to move in reverse.
ATTENTION:
the reverse speed is lower than the forward speed to comply with current health and safety standards.
N.B.:
In order to disengage the reverse gear, disengage the lever (1) underneath the steering wheel (
Fig.1
).
N.B.:
Once the lever has been engaged (1), the acoustic signalling device will be activated in order to signal that the machine's reverse
gear has been engaged.
21
6
7
5
1
1
4
5
2
3
3
2
3
3
4
2
1
2
1
6
5
4
4
5
7
Summary of Contents for BMg Sanitizer
Page 1: ...ORIGINAL INSTRUCTION DOC 10095868 Ver AA 03 2020 USE AND MAINTENANCE MANUAL BMg Sanitizer...
Page 2: ......
Page 27: ......
