Fiery E100 Color Serve, Service Manual

Page: 38 / 90

C
OMPONENTS
38
DIMM
The E100 includes a 1GB DIMM (dual in-line memory module) in the DIMM1 socket. It is
held in place on the motherboard by levers at each end of each the socket. Approved DIMMs
are available from your authorized service support center.
F
IGURE
16: DIMM
T
O REPLACE OR UPGRADE A
DIMM
You must follow standard electrostatic discharge (ESD) precautions when you handle
electronic components. For more information, see
“Standard electrostatic discharge
precautions” on page 11.
1. Shut down and open the E100 (see page 14 ).
2. To release the DIMM, push outward on the lever on each side of the DIMM (see Figure 16 ).
3. To avoid damaging the DIMM or the socket, slide the DIMM straight out of the socket, and
then set the DIMM aside.
4. To install a DIMM, insert it straight into the DIMM1 socket; insert one end, and then the
other end into the socket. Make sure that the levers snap into place.
The DIMM fits the socket only one way. The notch on the bottom of the DIMM should line
up with the notch in the socket.
Make sure that the levers close securely around the ends of the DIMM and that the DIMM is
fully seated in its socket. Avoid flexing the board while you firmly seat the DIMM in its
socket.
Lever
Lever
Socket notch
DIMM