QuickServer Start-up Guide
Page 33 of 43
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix D
Reference
Appendix D.1.
LED Functions
Light
Description
SPL
SPL LED will be on when a configured node in the QuickServer is detected as being offline. See Node
overview screen of the FS-GUI for further details.
RUN
RUN LED will flash 20 seconds after power up, signifying normal operation. The QuickServer will be able
to access FS-GUI (refer to Section 5.3 for more information) once this LED starts flashing. During the first
20 seconds, the LED should be off
ERR
The ERR LED will go on solid 15 seconds after power up. It will turn off after 5 seconds. A steady red light
will indicate there is a system error on the FieldServer. If this occurs, immediately report the related
“system error” shown in the error screen of the FS-GUI interface to FieldServer Technologies for
evaluation.
RX
On normal operation of FS-QS-10XX, the RX LED will flash when a message is received on the field port of
the QuickServer.
TX
On normal operation of FS-QS-10XX, the TX LED will flash when a message is sent on the field port of the
QuickServer
PWR
This is the power light and should show steady green at all times when the QuickServer is powered.