Outline of the A440 Series
FIC A440 Series Service Manual
1-23
Table 1-9
I/O Device Configuration Sub-Menu Options
Serial port A
[Disabled] / [Auto] /
[Enabled]
Configure serial port A using options:
Disabled - No configuration,
Enabled - User configuration,
Auto - BIOS or OS configuration.
Base I/O address
[3F8 IRQ4]
/ [2F8 IRQ3] /
[3E8 IRQ4] / [2E8 IRQ3]
Set the base I/O address for serial port A.
Parallel port
[Disabled] / [Auto] /
[Enabled]
Configure parallel port using options:
Disabled - No configuration,
Enabled - User configuration,
Auto - BIOS or OS configuration.
Mode
[Uni-directional]
/ [ECP] /
[Bi-directional]
Set the mode for the parallel port using
options.
Base I/O address
[378]
/ [278] / [3BC]
Select the base I/O address for the
parallel port when port is Enabled.
DMA channel
[DMA 0] /
[DMA 1]
Set the DMA channel for the ECP mode.
Floppy disk
controller
[Disabled] /
[Enabled]
Configure the floppy disk controller using
options:
Disabled - No configuration,
Enabled - User configuration
If you disable a device in Setup, you cannot enable or assign it using the
Windows (95 or 98) Device Manager. The device is not listed in the Windows
device list. You need to select any setting other than “Disable” in Setup.