FibberservCL FSAC201, User Manual

Page: 32 / 60

2.2. Buttons Introduction
Test/mute button
• Test the device to confirm it is able to work.
Reset button
•
Set the device to join the ZigBee network.
•
Reset this device to factory default settings.
2.3. LED Indicator
The LED indicator status is as below:
3. Get started
3.1. To get started, you will need:
•
FSSEG-X3 Smart Gateway
•
FSSD324 Smoke Detector
•
The Fiberserv mobile app
Then follow the steps below:
Step 1: Remove the pull tab to power on the device.
Tip: If the there is no battery inside, please install a CR123A battery into it.
Step 2: Select “Add new devices” in the menu of the app.
LED Status What it means Alarm sound
Red LED flashes quickly 1) Testing 2)Alarm Rapid beeps
Red LED flashes every 40
seconds
1) Lower power mode 2) Fault Beeps every 40 seconds
Green LED flashes The device is prepared to join a network. No
Green LED flashes six times The device leaves the network No