FibberservCL FSAC201, User Manual

Page: 17 / 60

2.2. Buttons Introduction
Rotary button
•
Turn ON and OFF the LED bulb.
•
Adjust the brightness of the LED bulb.
•
Adjust the colour and temperature of the LED bulb.
Reset button
•
Return the device to default factory settings.
•
Set the device into pairing mode to pair with an LED bulb.
Release Catch
•
Push and turn in the direction of the arrow to remove from the back plate. This will allow battery
fitment and replacement.
Color Temperature/Brightness selector switch
•
Select colour and temperature adjustment
•
Select brightness adjustment
3. Get started
To get started, you will need
:
•
A SEG-X3 Smart Gateway
• A LED622 ZigBee CCT Tunable LED bulb
•
A SLC603 ZigBee Dimmer Switch
•
The Fiberserv mobile app
Then follow the steps below:
Step 1: Install the batteries
Remove the device from its back plates as described previously, fit the batteries and re-assemble.
Step 2: Check the switch status
Press the rotary button and check if the LED indicator light is flashing red.
Tip: if not, please return it to default factory settings by using a pin key tool to press and hold the
reset button for ten seconds until the LED indicator flashes twice.
!
Tip: for this step, you could also press the “Z” button of the gateway for two seconds until the LED
indicator turns solid blue.