Fiat 2013 Ducato 250, Owner'S Handbook Manual

Page: 188 / 331

Please note that:
❒
the jack weight is 4.5 kg;
❒
the jack requires no adjustment;
❒
the jack cannot be repaired: in the event of a fault
it must be replaced by another original one;
❒
no tool other than its cranking device may be
fitted on the jack.
WARNING
No tools other than the crank provided
should be used with the spare wheel
lifting device; it should be operated by hand
only.
To change a wheel proceed as follows:
❒
stop the vehicle in a position that is not dangerous
for oncoming traffic where you can change the
wheel safely. The ground must be flat and
sufficiently compact;
❒
turn the engine off and pull up the hand-brake;
❒
engage first gear or reverse;
❒
put on the reflective safety jacket (compulsory by
law in certain countries) before getting out of the
vehicle;
❒
indicate that the vehicle has broken down using
the devices required by the law in the current
country (e.g. warning triangle, hazard lights, etc.);
❒
take the extension arm and the wrench from the
tool kit under the passenger seat (see
“Compartment under front passenger seat” in the
“Know your vehicle” section);
❒
for versions with alloy rims, remove the
press-fitted hub cap;
❒
loosen the bolts on the wheel to be replaced by
one turn;
❒
turn the wheel to extend the jack partly;
❒
arrange the jack near the lift support closest to
the wheel to be replaced at the points shown in
fig. 168. For short wheelbase versions with
retractable footboard, the jack must be positioned
at the lift point shown in fig. 169 aligned (45°) so
that it does not interfere with the retractable
footboard;
fig. 168
F0N0193
184
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX