Festo MPA-L Series, Description

Page: 125 / 160

5. Conversion and maintenance
5−25
Festo P.BE−MPAL−EN en 1008NH
4. Loosen the two tie rod screws on the left−hand end plate
of the CPX terminal using an Allen key, size3, without
pulling them fully out.
5. With the aid of a suitable tool, e.g. a screwdriver , remove
the appropriate fastening and locking plate in the pneu
matic interface (see Fig.5/10).
Now you can separate the pneumatic interface from the
modules of the CPX terminal.
1
Tie rod screw
2
Fastening plate
and locking plate
in the pneumatic
interface
3
Screwdriver
1 2
3
1
Fig.5/10: Dismantling on the side of the CPX terminal
Information about conversion and extension of the
CPX terminal can be found in the CPX system manual
type P.BE−CPX−SYS−....