Festo IIFB9-02 Series, Manual

Page: 53 / 165

4.3 INSTALLING THE ELECTRONIC COMPONENTS
WARNING
Before installation or maintenance work
is carried out the following must be switched
off:
•
the operating voltage for electronic
components and/or inputs
• the operating voltage for outputs
•
the compressed air supply
The necessary pre-settings and the connections
to the electronic components are described in
this chapter. The following table (sections 1. ...4.)
summarizes the procedure.
1. Switching off
• Operating voltage
•
Compressed air supply
2. Opening the field bus node
Configuring the valve terminal/valve sensor terminal
• Address selector
switch
(Setting the station number)
• DIL switch (Setting the station number,
protocol and self-test
3. Closing the field bus node
Connecting the valve terminal/valve sensor terminal
• General (Connecting plugs, sockets)
• 24V operating voltage connection
• Field bus interface (Connecting the interfaces
and, if necessary,activating
the cable termination network
• Outputs (Pin assignment)
• Inputs (Pin assignment and circuitry)
Checking the pre-settings and connections
4. Switching on
•
Operating voltage (see Chapter 5)
• Compressed air supply
VIFB9 - 02 4. Installation
4-16
9609