Festo IFB11-03, Electronic Manual

Page: 38 / 214

2. Fitting
2−10
Festo P.BE−VIFB11−03−EN en 0503g
4. Fasten the valve terminal, depending on the type, as
shown in the following table. The valve terminal can be
fitted in any desired position.
Type of valve terminal Fastening methods
Type 03 with four M6 screws on the left−hand and
right−hand end plate.
In the case of valve terminals with several I/O
modules, use additional support brackets for the
modules (approximately every 200 mm).
Type 04−B with two M6 screws on the left−hand end plate
with three M6 screws (ISO sizes 1 and 2) or
M8 (ISO size 3) on the adapter plate and on
the right−hand end plate.
If required, use the following additional methods
of fastening:
a fastening screw per manifold sub−base
the hole on the bottom of the manifold sub−
base (blind hole", see Pneumatics manual)
In the case of valve terminals with several I/O
modules, use additional support brackets for
the modules (approximately every 200 mm).
Fig.2/4: Possibilities for fitting onto a wall