Festo ELGA-BS-KF, Operating Instructions Manual

Page: 26 / 112

ELGA-BS-KF
26 Festo – ELGA-BS-KF – 1508NH English
Interfaces for mounting components
On the cover
On the profile
e.g. with foot mounting HPE
1)
e.g. with slot nuts NST
1)
e.g. with profile mounting MUE
1)
1) Accessories
è
www.festo.com/catalogue
Fig. 6
Note
Danger of screws being pulled out if the axis is only mounted to the covers and the
torque load around the longitudinal axis is too great.
If there is high loading, mount the axis on the profile with additional mounting com­
ponents.
Select mounting components (
è
www.festo.com/catalogue).
Mount the mounting components outside the positioning range (avoid collisions).
Fasten axis.
Evenly tighten screws.
Size 70 80 120 150
Screw (cover) M5 M8
Tightening torque [Nm] 6 24
Tab. 1
5.1.2 Mount attachment components
Requirements
Note
A warped attachment component bends the slide
and shortens the service life of the guide.
Use an attachment component with an even
surface.
Evenness: t = 0.01 mm
Fig. 7
t