47 / 56
Festo 7DSBCa_en
All sizes
31. Apply thin film of grease on the buffer seals on the front side facing the
sealing surface and on the sealing lip using the grease included in the set of
wearing parts.
32. Insert the buffer seals into the bearing and end caps.
33. Place the holding discs on the bearing and end caps.
34. Grease the O-rings with the grease included in the set of wearing parts.
35. Insert the O-rings into the slot of the bearing and end cap.
Note
To avoid damage to the bearing and scraper ring:
Place the matching mounting sleeve on the thread of the piston rod
(
36. Guide the bearing cap over the mounting sleeve on the piston rod up to the
cylinder barrel.
37. Place the end cap on the cylinder barrel.
38. Clean flange screws to remove screw locking agent.
39. Wet the flange screws with screw locking agent.
40. Screw in the flange screws.
41. Align the bearing and end cap flush with the cylinder barrel.
42. Tighten the flange screws with the appropriate tightening torque.
Size
Tightening torque
DSBC-32
7 Nm
DSBC-40
7 Nm
DSBC-50
13 Nm
DSBC-63
13 Nm
DSBC-80
25 Nm
DSBC-100
25 Nm
DSBC-125
60 Nm
43. Perform a functional test or start up the repaired ISO cylinder as described
in the operating instructions.
The operating instructions are enclosed with the ISO cylinder or can be
called up on the Festo website (
).
