Subject to change – 2018/04
20
è
Internet: www.festo.com/catalogue/...
Terminal CPX-P
Key features – Assembly
Mounting options
Valve terminals with CPX-P terminal
support different mounting options
for direct machine mounting with high
protection and control cabinet
installation.
H-rail mounting
A
B
The rear profile of the CPX-P interlink
ing block has a preformed H-rail
mounting so that the CPX-P terminal
can be attached to the H-rail using the
H-rail mounting kit.
The CPX-P terminal is mounted on the
H-rail (see arrow A) and
then swivelled onto the H-rail and
secured in place with the clamping
component (see arrow B).
The optional earthing plate enables a
connection to be established to the
machine potential/earth in one easy
step.
For H-rail mounting you will need the
following mounting kit:
CPX-CPA-BG-NRH
This facilitates mounting of the CPX-P
terminal on H-rails to EN 60715.
An additional mounting kit is required
for combination with valve terminals.
Wall mounting
The end plates of the CPX-P
terminal, the valve terminal and the
pneumatic interface include
mounting holes for wall mounting.
Additional mountings for the CPX-P
terminal are available for longer
valve terminals.
Additional mounting components
Additional mounting brackets for the
CPX-P terminal that can be screwed
onto the interlinking blocks are
available for longer valve terminals.
-H-
Note
For CPX-P terminals with 4 or more
interlinking blocks: you will require
additional mounting brackets of the
type CPX-M-BG-RW approx. every 100
or 150 mm. These are supplied pre-
assembled.
Linking with screws
The mechanical connection between
the CPX-P modules is created using
special angle fittings.
The CPX-P terminal can thus be
expanded at any time.
