Installation
ATTENTION!
Note: If no reception is possible it has to be checked whether any
metallic cupboards or other metallic obstacles may interfere.
Note: During a demand the LED will show a solid light.
LED
Button
9
Location
Emergency running mode
If no valid radio signal is received from the transmitter, the receivers LED light will flash
every half second. After 1 hour the boiler will operate in ‘Emergency Mode’ (heating for 4
min. and off for 9 min.). Ensure the batteries are ok, replace batteries if necessary.
Radio link installation
1. Press receiver button and hold down for 2
seconds. The LED flashes twice. Then release
the button. The LED remains on between 1 and
10 seconds. When a correct link between the
transmitter and receiver has been established
the LED goes off. Subsequent RF transmissions
are indicated visually by a momentary flash of
the LED (approx every 5 seconds).
2. Install the batteries onto the transmitter, the
receiver LED will go out. The radio link between
the transmitter and receiver is now established.
Summary of Contents for 30800013
Page 14: ...14 Notes...
Page 15: ...15 Notes...
