Ferrari GTC 4 Lusso, Roadside Assistance Manual

Page: 43 / 45

3
Towing the vehicle
43
Once the electric parking brake has been manually released, the EPB node
records a failure at the next key-on and a special symbol and the following
message are displayed on the left TFT display: “Parking Brake system
revision. Go to dealer”.
Warning
The parking brake resumes normal operation, but it is important to go
to the nearest workshop to have it calibrated and delete any errors in
the error memory. Go to a F
ERRARI
S
ERVICE
C
ENTRE
. Calibration is
necessary for safety reasons.
Park Lock emergency release
Warning
The emergency release procedure must only be carried out by
specialised workshop technicians. If the system cannot be released,
contact the nearest F
ERRARI
S
ERVICE
C
ENTRE
.
Warning
This should be avoided unless absolutely necessary:
- to tow the vehicle;
- if there is a Park Lock failure (displayed on the left TFT display with
the message “Only manual unlock gearbox allowed: See handbook”).
Warning
When the Park Lock safety device is deactivated manually, the vehicle
may move unexpectedly. The vehicle is only kept stationary by the
parking brake, if applied.
The Park Lock manual emergency release device is found in the top right
of the tool kit, as shown by the arrow in the figure.
To perform the Park Lock emergency release procedure, do the following:
●
• Take wrench D out of the tool kit.
Warning
Wrench D may only be used by specialised workshop technicians, as
indicated on label C on the tool bag.
●
Remove the rubber protection cap E .
●
Place wrench D in the manual release device housing F .
●
To perform the emergency release, turn wrench D clockwise for a
quarter turn.
If the electrical system allows it, check that the letter “N” appears on
the gearbox display by activating the instrument panel. The following
message will appear on the left TFT display: “Gearbox not in Parking
position”. At the same time, an audible signal is repeated four times to
indicate that it has been released.
D