12
© Ferno-Washington, Inc. 234-3388-01 June 2008
Accessory Kit 082-2012
Figure 18 - Reconnecting Battery #2
Figure 19 - Pressing Battery #2 to Hooked Fastener
Strip After Routing Wires Between Batteries
3.8 verify the Installation
1. Make sure cot is in OFF position.
2. Put the POWERPac in place beneath the backrest and
attach the Control Unit and Actuator Unit cables to the
POWERPac. Also attach the charging cable if using the
ICS
®
or BCS.
3. Turn the cot power switch ON. Confirm that the green
light in the power switch is lit.
4. Press the green RAISE/UNLOAD touch pad and confirm
that the cot moves up when the touch pad is pressed.
5. Press the blue LOWER/LOAD touch pad and confirm that
the cot moves down when the touch pad is pressed.
6. Turn the cot power switch OFF. Press each touch pad and
confirm that the cot does
not
move when the power is off.
7.
If the cot operates properly
, return it to service.
If the
cot does not operate properly:
° Open the POWERPac.
° Follow Steps 1-9 in
Install the New Batteries
, (page
11-12) as a guide for checking that the batteries are
properly installed.
° Re-test the cot, following Steps 1-6 above.
If the cot still does not function properly, contact Ferno
Customer Relations, EMSAR or your Ferno distributor
for service (page 13).
3.7 Close the POWERPac Housing
Note:
Make sure both circuit breakers are not tripped before
closing the POWERPac.
1. Gather two wires from the upper housing and coil together
above the lower housing as the upper housing is placed
onto the lower housing. Ensure no wire or connector is
trapped between the housings, gasket or batteries.
2. Use the #1 Phillips screwdriver and 11/32˝ wrench to
secure the upper housing to the lower housing with the
12 screws and nuts removed while preparing to install
the kit.
Note:
Assemble the housing with the screws at the top of the
upper housing and the nuts under the lower housing.
5. Attach the black [jumper] wire connector to the positive
(red) battery terminal on battery #2 (Figure 18). Use 3˝
tape to secure wire to battery #2.
7. Attach the black wire [24 -] connector to the negative
(black) battery terminal on battery #2. Use 3˝ tape to
secure wire to battery #2.
8. Hold battery #2 with the looped fastener strip facing
down and the terminals facing the center of the housing.
Press the battery onto the hooked fastener strip in the
bottom of the case. The wires should be routed between
the batteries (Figure 19).
9. Attach the black wire [jumper] to negative tab of battery
#1. Use 3˝ tape to secure wire to battery #1.
Summary of Contents for 082-2012
Page 14: ......
