Fermax SKYLINE MDS 7460, Technical Book

Page: 16 / 58

Repeat with all Decoder outputs
This option allows you to program the MDS or VDS decoders configuring the different panel general parameters.
Starting from the general DECODER PROGRAMMING option, follow the indications on the following diagram and
table:
Repeat these steps for all
Decoders to be programmed
PROGRAMMING
PRG
PANEL PREPARED
INDICATIONS
DISPLAY
OBSERVATIONS
The panel is already prepared for programming the Decoder. You
have 120 seconds to put the decoder in programming mode.
Press the programming button of the decoder to be programmed.
The Display will indicate the type of Decoder to be programmed
Possible values:
dEc.4: Decoder MDS de 4 outputs (or Decoder VDS configured
as range)
dEc.8: Decoder MDS de 8 outputs (or Decoder VDS configured
as DECODER 8)
DECODER PREPARED
PREPARAR DECODER
PROGRAM DECODER
If a MDS DECODER or VDS DECODER VDS configured as a DECODER 8
Press the button to assign a telephone connected to the
first decoder output, or
Dial the number of the home to assign (two digits), or dial
A if you want to exit without programming. (It is really
programmed with the code "0 0 0 0".
Repeat these steps with the remaining decoder outputs
DISPLAY INDICATIONS
" - - - -" : the decoder output has not been programmed yet.
" x x x x" : telephone number to be programmed.
If an Interior Block panel, the assigned number is automatically that of the
Interior Block Number.
After confirming with "S":
"E r r " : the number being programmed is already assigned.
"Good" : the number has been programmed correctly.
Audio is established between the panel and the decoder, so you can communicate via the
panel and decoder by connecting a telephone jack to this..
Decoder Programming
PRG
Audio ON
S
S
S
S
Audio ON