Fermax SKYLINE MDS 7460, Technical Book

Page: 10 / 58

The MDS systems that have some type of Central Guard Unit may function in DAY MODE: The calls from the street
panels to the homes are only received in the Guard unit, or in NIGHT MODE, the calls are received in the homes.
Changing from one mode to another is done from the Central Guard Unit.
A system may be configured in DAY MODE, and not be able to make the change to NIGHT MODE, since the Central
Guard Unit isn't available or accessible. In this situation, the calls are not received in the homes, but are forwarded
to the Central Guard Unit (even if the central is not physically connected).
From the panel with Digitiser you can restore the NIGHT MODE panel and then allow for calls to homes.
This operation is only done via the panels with keypad module, or provisionally connected to a module.
The procedure is the following:
- Press the "A" key
- Mark the sequence "3 - 1 - 4 - 1"
- Mark the sequence "0 -0 -0 -0" (twice).
This resetting can also be done via the programming. See the SYSTEM PROGRAMMING section.
RESTORING NIGHT MODE
OPENING THE DOOR WITH THE PIN
The panels with keypad module have the front entrance door open function via a general 4-digit PIN. Upon entering
this code via the keypad, you can open the door.
This code is programmed and active via the SYSTEM PROGRAMMING (see the corresponding section), even
though it can be changed later from the keypad itself. It can be deactivated as well. To activate and program again,
you need to do so via the SYSTEM PROGRAMMING, that is, accessing the front part of the panel.
The way to open the door via the PIN is as follows:
- Press the A key
- Mark the PIN code. The "door" icon on the digitiser's front OneToOne is lit.
The procedure for changing the code via the keypad is as follows:
XXXX: Current code
DESCRIPTION OF THE MDS DIGITISER REF. 7460
3141
0000 0000
A
XXXX
A