Page 36
LYNX Monitor
To change the mode, you need to press the desired alarm icon. The following modes may be
selected:
HOME.
Change to House mode. All sensors are disabled, except those in 24/7 areas, which
remain armed.
SLEEP.
Change to Night mode. All sensors in 24/7 areas and Night areas are armed
OUT.
Change to Outside mode. All sensors are enabled, (All areas are armed: 24/7, Night and
Outside).
When you step down to a lower-level security mode (for example: from OUTSIDE to HOME or
from NIGHT to HOME), the
alarm PIN
code will be requested, which by default is
0000
, and
you will then need to press
OK
. For security reasons, we recommend changing it. If the security
level is higher, no PIN will be requested.
Notes:
- If you change the mode while no areas are activated, the monitor will arm in the corresponding mode.
If any area is active at that time, the monitor will warn you and display it on the screen. Should any of
the active areas be instantaneous, the monitor will not allow the mode to be changed.
- If an incorrect PIN code is entered 5 consecutive times, an alarm message will be sent to the Property
Alarm Management Unit (Concierge).
The corresponding alarm LED shows the current status. The monitor periodically checks the
alarm status and activates the corresponding LED (HOUSE, OUTSIDE, NIGHT).
Notes:
- If no Sensor Module is detected or confi gured, the alarm LED will not light up.
- If communication between the Sensor Module and the monitor fails, it is reported to the PMU and the
corresponding LED icon on the monitor goes out.
SOS
HOME mode.
(green)
