Manual Tune
To manual tune to the frequency, long press the
[OK]
on remote or long press
[Tune/Select]
on the unit, until you see the
"Tuning"
appeared on the display, at the bottom right corner. Use
the
<◄ / ►>
button on remote to tune the frequency. When done, long press the
[OK]
button to
exit manual tune.
11. Bluetooth playback
Before transmission between your Bluetooth device and the radio is possible, both devices must be
coupled. This process is called "pairing". The radio is served as a receiver, to receive music stream to
play on the radio.
If you have already coupled to a Bluetooth device before, this connection will be restored
automatically when both devices are in range and Bluetooth operation has been selected on the
radio. "Pairing" does not have to be repeated. This function may need to be activated in your
Bluetooth device, however.
• Push the Menu button to display the selection menu for the different operating modes.
• Use the up/down button to select the operating mode Bluetooth and push the dial switch.
• Switch your Bluetooth device to which you want to connect the radio on and activate the
pairing mode here. The device scans for Bluetooth devices in the reception range.
• When the radio is found, your bluetooth device shows its name Regent i100-XXXX (the
XXXX is an
identification code for your radio unit).
• Select the radio at your bluetooth device.
• Start playback on your bluetooth device.
• Playback now takes place using the radio.
12. Aux-In
You can listen to the music stored in other audio device or smart phone on the radio, through the
connection to the 3.5 mm aux-in jack on the rear side. Use the cable with both ends in 3.5 mm pin,
one end to the aux-in jack on the radio, the other end to the earphone jack on the audio device or if
it has line out socket.
14:30
FM101.80MHz
i
:ic
< PRESET 12
12/13
Tuning
