C)RAISED INSTALLATION – FOR TRUCKS & SUV WITH
STEP BUMPERS
(This will raise the camera frame out of
the cavity of the step bumper)
1. Unscrew and remove your
license plate.
2. Install the Two Way Mounting
Tabs using original Plates Screws
and Mounting Screws.
3. Finally, install the Smart HD Solar
Wireless Backup Camera and
license plate onto the rear of your
vehicle and tighten the Mounting
Nuts with a wrench.
Original Plate Screw
Step Bumper
Mounting
Screw
Two Way
Mounting Tab
Mounting
Nut
Warning:
Lower tailgate on pickup trucks slowly and check for minimum ¼
inch clearance between gate and top of camera frame. This check is because
some bumpers are installed higher than others.
FENSENS
FENSENS
06
