Page 6 / 16
Assembly instructions
Step 1) Take the 540gsm PVC ground sheet and lay it out on a level, earthy surface if possible. Make sure
that there is at least 1.5 metres of space all around for tensioning the ropes. Use the 12 steel pegs Ø5mm
and a rubber mallet to attach the PVC ground sheet to the eyelets provided. Do not tension the tent too
tightly, otherwise it may cause problems when pitching.
Step 2) Place the cotton canvas tent roof over the attached PVC ground sheet. Align it so that the
entrance of the tent is in the desired location. Before erecting the tent, make sure that the ventilation
valves at the top of the tent are locked open. Now put the 3-piece steel centre pole together and go
under the cotton canvas tent roof. Use the 3-metre steel centre pole to push the tent up at the peak of
the tent. Place the other end of the steel centre pole on the marked spot by the PVC ground sheet.
Connect the cotton canvas tent roof to the PVC ground sheet using the zips provided.
Step 3) Put the 3 components of the tent entrance together (2x steel tube pole + 1x curved steel tube
pole). Put the assembled door arch into the pockets provided, which are located next to the tent
entrance at the bottom of the PVC ground sheet. At the top of the door arch there is a point which must
be passed through the eyelet above the tent entrance. Then press the plastic rain cap over the tip of the
door arch.
Step 4) Fasten the pre-installed nylon cords to the tent roof with the flat steel peg incl. rubber hammer
into the ground. Make sure that the cord runs in a straight line to the cord connection to the tent roof.
When setting up the tent for the first time, do not pull the tent too tight. The tent requires a one-time
weathering process. This process is described below.
DE
EN
FR
IT
1x Centre pole
1x Door arch
13x Guy ropes
Pegs & Stakes
1x Plastic rain cap
Ground
Zipper
