Fema Electronica K40-CR, User Manual

Page: 16 / 28

FEMA ELECTRÓNICA . Series K . K40-CR
16
1.13 Full configuration menu (cont.)
Tools
Key UP
(‘Fast access’)
Memory of
maximum
Memory of
minimum
Setpoint 1
Setpoint 2
Setpoint 3
Memory of
cycles
Preset value
Password
Factory reset
Left zeros
With left zeros
Without left zeros
Version
Minimum
Brightness
Maximum
Standard
Option 2
Configuration menu for the module installed at Opt.2
Option 3
Configuration menu for the module installed at Opt.3
1.14 Factory configuration
Function mode
View format MM.SS
Counting direction up
Preset 00.00
Configuration
‘On power-up’
Delay 0 seconds
Reset off
State stopped (‘StoP’)
Flash
‘Flash on stop’ off
‘Flash on start’ off
Rear reset activates by edges (‘EdGE’)
Function on channel ‘B’ no
Controls
Pulls for ‘start’ and ‘stop’ pull-up (‘P.uP’)
Activation for ‘start’ and ‘stop’ by falling edge (‘on_0’)
Pulls for reset pull-up (‘P.uP’)
Activation for reset by falling edge (‘on_0’)
Trigger level 2.56 Vdc (level 20)
Excitation voltage 15 Vdc
Antirrebound filter disabled (0 mSeconds)
Alarms 1,2 and 3
Mode off (disabled)
Type of alarm of maximum
Setpoint 0
Activation delay 0.0 seconds
Deactivation delay 0.0 seconds
Inverted relay off
‘Locked alarms’ off
‘On alarm’ continue
‘Alarm flash’ off
Herramientas (‘TooL’)
‘Fast acess’ (key UP) off
Setpoint 1 off
Setpoint 2 off
Setpoint 3 off
Memory of maximum off
Memory of minimum off
Cycles off
Preset off
Ley ‘LE’ reset function
Left zeros off
Password off
Brightness 3
on
off
Key LE
Reset
Alarm unlock
No function
Reset + Start
Option 1
Configuration menu for the module installed at Opt.1