YAMAHA
*The wire connections are the same for
the external kill switch and kill switch
mounted in the throttle casing.
Battery
Close to Stop
Main Power Switch
Fuse
1-3 A
10 - 32 VDC
From existing
Kill Switch
Black/White
Black
Switch position in
inactive mode e.g.
engine not running.
5-pin IP67
Connector
Max Internal Switch load: <5A
Min. Power Voltage: 7V
-Below this voltage the unit will
turn off.
To engine
harness
To xHUB
Parallel
Connection
Inline with existing kill switch:
RECOMMENDED
RECOMMENDED
Make sure that all
wire connections are
waterproof by using
marine grade butt
splices or similar when
connecting wires.
Avoid cutting or modifying original kill
switch wiring
IMPORTANT
MOB+ xHUB
MOBP17022
If keeping mechanical kill switch
in place, connect MOB+ in parallel
with mechanical kill switch to
avoid potential danger from a non-
functional mechanical kill switch.
MERCURY
To engine
harness
To xHUB
Parallel
Connection
Inline with existing kill switch:
*The wire connections are the same for
the external kill switch and kill switch
mounted in the throttle casing.
Battery
Close to Stop
Main Power Switch
Fuse
1-3 A
10 - 32 VDC
From existing
Kill Switch
Black/Yellow
Black
Switch position in
inactive mode e.g.
engine not running.
Max Internal Switch load: <5A
Min. Power Voltage: 7V
-Below this voltage the unit will
turn off.
5-pin IP67
Connector
RECOMMENDED
If keeping mechanical kill switch
in place, connect MOB+ in parallel
with mechanical kill switch to
avoid potential danger from a non-
functional mechanical kill switch.
RECOMMENDED
Make sure that all
wire connections are
waterproof by using
marine grade butt
splices or similar when
connecting wires.
Avoid cutting or modifying original kill
switch wiring
IMPORTANT
MOB+ xHUB
MOBP17021
MOB+ MULTIPLE ENGINE HARNESS (MOB+ MEH)
R E D
B L A C K
G R A Y
B L U E
O R A N G E
Fuse 1A
Main Power Switch
COLOR ID:
White = Signal
Black = Ground
!
*Multiple Engine Harness kit includes User
Manual, please read this carefully before
installing this product.
Part name:
MOB+ Multiple Engine Harness
P/N: (F-A/N):
72.380.401
Availability:
FELL Marine dealers and buy.fellmarine.com
For multiple outboard installations, the black (-) battery cable of each engines starter motor
ground circuit, MUST BE connected to each other by a common circuit (cable) capable of
carrying the starting current of each engines starter motor. (i.e. A locally obtained battery
cable connected between the negative (-) terminal of each outboards cranking battery.)
CAUTION
This product is designed to be used in conjunction with the MOB+ xHUB to stop
multiple engines simultaneously for multiple outboard installations. The MOB+
xHUB should be installed prior to installation of this Multiple Engine Harness.
IMPORTANT
• WHITE wire on MOB+ MEH is signal wire; each engines signal
wire must be connected to the WHITE wire on the MOB+ MEH.
• BLACK wire on the MOB+ MEH is GND wire; each engines
GND wire must be connected to the BLACK wire on the MOB+
MEH.
• Connect WHITE and BLACK wires in pairs as bundled on
the MEH kit.
MOBP17023
FOR OTHER ENGINE BRANDS SEE WWW.FELLMARINE.COM/SUPPORT
© FELL Technology AS
Page 7/9
WIRING SECTION
MARCH 2018
REV200-0318