Felker Mason Mate II, Operating Instructions And Parts List Manual

Page: 6 / 56

6
SAFETY FIRST!
WARNINGS
DO's and DO NOT's
WARNING:
FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO
DO read this entire operator’s manual before operating this machine. Understand all warnings, instructions, and controls.
DO keep all guards in place and in good condition.
DO wear safety approved hearing, eye, head and respiratory protection.
DO read and understand all warnings and instructions on the machine.
DO read and understand the symbol definitions contained in this manual.
DO keep all parts of your body away from the blade and all other moving parts.
DO know how to stop the saw quickly in case of emergency.
DO turn the “ON/OFF” switch to the “OFF” position prior to connecting the machine to the power source.
DO inspect the blade, flanges and shafts for damage before installing the blade.
DO use only reinforced abrasive blades or steel center diamond blades manufactured for use on masonry saws.
DO use only the blade flanges supplied with the saw. Never use damaged or worn blade flanges.
DO use only blades marked with a maximum operating speed greater than the blade shaft speed. Verify speed by checking
bladeshaft RPM and pulley diameters.
DO verify saw drive configuration by checking blade shaft RPM and pulley diameters.
DO read all safety materials and instructions that accompany any blade used with this saw.
DO verify the blade arbor hole matches the machine spindle before mounting the blade.
DO inspect each blade carefully before using it. If there are any signs of damage or unusual wear, DO NOT USE THE BLADE.
DO mount the blade solidly and firmly, Wrench tighten the arbor nut.
DO make sure the blade and flanges are clean and free of dirt and debris before mounting the blade on the saw.
DO use the correct blade for the type of work being done. Check with blade manufacturer if you do not know if blade is correct.
DO use caution and follow the instructions when loading and unloading the machine.
DO operate this machine only in well ventilated areas.
DO instruct bystanders on where to stand while the saw is in operation.
DO establish a training program for all operators of this machine.
DO clear the work area of unnecessary people. Never allow anyone to stand in front of or behind the blade while the motor is
running.
DO make sure the blade is not contacting anything before starting the motor.
DO use caution and follow instructions when setting up or transporting the machine.
DO always tie down machine when transporting.
DO have all service performed by competent service personnel.
DO make sure electric powered saws are plugged into a properly grounded circuit.
DO make sure power cords are proper size and in good condition.
DO keep cord away from heat, oil and sharp edges.
DO maintain a secure grip on the material being cut.
DO clean the water tray frequently.
DO verify the blade arbor hole matches the machine spindle before mounting the blade.
DO clean the machine after each day’s use.
DO follow all electrical codes in your area.
DO disconnect tools from the power source when not in use, before service and when changing accessories
DO always give a copy of this manual to the equipment user. If you need extra copies, call TOLL FREE 1-800-365-4003.