FEIN
– REPAIR - TOOLS
All rights reserved by FEIN, especially in case of industrial rights registration.
Any power of disposition such as copying and right of transfer is situated with FEIN.
Sahre / MVK 05 / 2011
4.2. Disassembly - Feed unit
Remove plastic cover
Loosen nut with ring wrench (tightening torque during assembly:
1 Nm
–
must be complied with,
otherwise the automatic feed will not work correctly. Remove Loctite residue on threaded bar and nut
and clean parts. During assembly, moisten threaded bar with Loctite 242, then tighten nut to 1 Nm).
Remove spider with feed motor
Warning - when removing the spider, carefully slide the feed motor connection cable through
the jig housing
–
the plug is relatively big, be careful not to bend the cable
Tools:
- slotted screw driver
- ring wrench 13 mm
