19
en
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 8 – 9).
Check the power supply cable
and the plug for damage.
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
The
self-start lock
prevents the angle grinder
from automatically restarting again, even after
a brief interruption of the power supply, e.g.,
from a pulled mains plug.
Switching on without lock-on function:
Press the safety lock and the On/Off switch
(I)
at the same time.
Release the safety lock again.
Switching off:
Release the On/Off switch
(
)
.
WARNING
WARNING
CAUTION
OBJ_BUCH-0000000073-001.book Page 19 Wednesday, May 30, 2012 3:17 PM