OBID i-scan
®
System-Manual
ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH
Page 26 of 131
H60301-3e-ID-B.doc
GRN / RED / BUZZER (PRH: BLUE instead of RED)
Bit Combination
Signal device
b00
unchanged
b01
on
b10
off
b11
flashing
Startup Buzzer / LED
(only idle state)
When this option is selected, the Reader will switch the BUZZER and the LEDs on
for two seconds to indicate that the Reader is ready after the Reader is supplied with
power. If the Reader is reset by software, only both LEDs switch on for 2 seconds.
IDLE-FLASH / ACTIV-FLASH:
By means of the two bytes "IDLE-FLASH" and "ACTIV-FLASH" the signal transmitter may be pro-
vided with a flashing frequency for idle and active position.
Bit:
7
6
5
4
3
2
1
0
Function:
0
0
BUZZER
RED
GRN
Bit combination
flashing frequency
b11
b10
b01
b00
1 Hz
2 Hz
4 Hz
8 Hz
ACTIV-xxx-TIME
If a Transponder was detected, the transmitter and the duration can be set by the bytes ACTIV-STATE
and ACTIV-FLASH. Each signal transmitter (LED, BUZZER) may be activated temporarily limited.
Signal transmitter
time range
ACTIV-GRN-TIME
0...255 x 100 ms
ACTIV-RED-TIME
0...255 x 100 ms
ACTIV-BUZZER-TIME
0...255 x 100 ms
