IDENTIFICATION
Installation
ID ISC.LRU1002
FEIG ELECTRONIC GmbH
Page 21 of 32
M61110-2e-ID-B.docx
4.4.4. Relay output on connector X4
There are 2 relay outputs (normally open) available on connector X4.
Figure 16: Relay outputs REL1 / REL2
Table 12: Pin Assignment Relay Outputs REL1 / REL2
CAUTION:
The relay outputs are configured for max. 24 V DC / 2 A constant load.
The switching current must not exceed 1A.
The relay outputs are intended for switching resistive loads only. If an inductive load is
connected, the relay contacts must be protected by means of an external protection circuit.
Figure 17: External wiring of the relay outputs
Pin Number
at Connector X4
Pin Assignment
5
REL1-NO
6
REL1-COM
15
REL2-NO
16
REL2-COM
