IDENTIFICATION
Installation
ID ISC.LRU1002
FEIG ELECTRONIC GmbH
Page 11 of 32
M61110-2e-ID-B.docx
4.3. Interfaces
4.3.1. Ethernet Interface on connector X1
The Reader has an integrated 10 / 100 base-T network port for an RJ-45. Connection is made on
X1
and has an automatic “Crossover Detection” according to the 100BASE-T Standard.
With structured cabling STP CAT 5 cables should be used. This ensures a reliable operation at
10 Mbps or 100 Mbps.
The prerequisite for using TCP/IP protocol is that each device has a unique IP address on the net-
work. All Readers have a factory set IP address.
Table 6: Standard factory configuration of the Ethernet connection
Network
Address
IP-Adresse
192.168.10.10
Subnet-Mask
255.255.0.0
Port
10001
DHCP
OFF
NOTE:
The reader is equipped with a DHCP ready Ethernet Interface.
4.3.2. USB Mini Interface on connector X3
The reader is equipped with a USB on-the-go interface. This can either be used to connect the
reader to a host system or by means of a special on-the-go adaptor for connection of a USB mem-
ory stick to the reader. In both cases the connection is carried out via terminal X3. The pinout is
standardized.
Figure 5: USB-Interface for host communication
A standard shielded USB-cable can be used for connection of the reader to a host system. The
data rate is reduced to 12 Mbit (USB full speed).
NOTE:
The length of the USB-cable can have a max. of 5m (20 inch). It is not allowed to use longer
cables.
