IDENTIFICATION
Installation
ID ISC.LRU1002
FEIG ELECTRONIC GmbH
Page 23 of 32
M61110-2e-ID-B.docx
5.2. Reset Push Button T1
By means of the push button T1 a complete configuration reset can be performed. The push button
is positioned in the middle between the antenna connectors ANT3 and ANT4. Figure 18 shows the
position of the push button. It is located inside the reader housing. To press the reset button T1
you should use a paper clip.
To reset the reader back to factory default push the button for at least 5 s until the 3 status LED
(left side) are switched on continuously. After releasing the push button the reader performs a re-
start.
During a complete configuration reset all parameters of the reader will be reset back to factory de-
fault and need to be configured again.
Figure 18: Position of the reset button T1
