Identification
Installation
ID ISC.ANT.U500/270
–GA/-GB UHF-Gate
FEIG ELECTRONIC GmbH
Page 13 of 54
M71060-1e-ID-B
4.2.2 Drilling the Mounting Holes
If the position of the antennas has been marked or determined, the mounting holes and the holes
for the cable entry, can be marked and drilled for the antenna foot.
The dimensions are shown in Fig. 6:
Adjustable feet
Mounting holes (max. M10)
Fig. 6: Floor plate dimensions
All dimensions are in mm with general tolerance to ISO 2768 m (middle).
The size and type of the anchors depends considerably on the strength of the base or floor. The
anchors should be capable of withstanding a permissible load of at least 5 kN per anchor for all
load directions (e.g. for concrete floor Hilti HVA anchors with HAS-(E) M8 threaded rod or Hilti HIS-
N M8 (5/16”) threaded inserts). The size of the mounting holes in the antenna is 10 mm (.39”). The
length of the anchors or bolts should be selected such so they just look out at least
35 mm (1.4”)
and maximum of 40 mm (1.6
”) of the floor.
Please follow the mounting instructions of the anchor manufacturer!
A cable opening is provided for the necessary connection cable (see Fig. 6).
cable opening
