-
Tighten the chuck jaws on the drill bit.
-
Make sure that the bit is well installed in place. Failure when installation will create
accidents and injuries
e. Removing bits
-
Switch off the tool and put the reverse/forward switch in the center position.
-
Open the chuck jaws and then pull the bit straight out.
f. Installing belt clip
-
Put the reverse/forward switch in the center position
-
To reduce the risk of serious personal injury, do not suspend tool overhead or
suspend objects from the belt hook. Only hang the tool’s belt clip from a work belt.
-
When attaching or replacing the belt clip, use only the screw that is provided. Be sure
to securely tighten the screw.
-
The belt clip can be attached either side of the tool using only the screw provided, to
accommodate left or right handed users.
-
To move belt clip, remove the screw that holds the belt clip place then reassemble on
the opposite side. Be sure to securely tighten the screw.
Note: the belt is not provided with the tool.
g. Starting and stopping the operation
-
Push the forward/reverse switch at the desired position (on the left for reverse
position and on the right for the forward position).
-
Move the drill bit into the workpiece. Push the trigger switch to start the operation.
-
Apply enough pressure to keep the bit cutting. Do not force the tool or apply side
pressure. Let the tool do the work. When necessary, increase the work speed by
pushing the trigger.
-
To change the position, release the trigger switch. Put the reverse/forward switch in
the center position (never change directly the position). Push the forward/reverse
switch to change the position. Push the trigger switch to restart the operation.
-
To stop the operation, release the trigger switch. Then put the forward/reverse switch
to the center position.
h. Drilling
Drilling hard smooth surfaces
Place a piece of masking tape onto the surface in the approximate position for the hole.
Mark the position of the hole onto the masking tape this will prevent the drill from the
skidding across the surface when the drill is started. Slowly drill through the surface.
Drilling metal
When drilling metal, use light oil in the drill bit to keep it from overheating. The oil will
prolong the life of the bit and increase the drilling action
