ORIGINAL INSTRUCTIONS > EN
18
engine is not in use.
NOTE:
When turning off the generator after LPG operation, make sure the LPG cylinder knob is in the
fully closed position.
NOTE
: If the engine will not be used for a period of two (2) weeks or longer, please see the Storage
section for proper engine and fuel storage
5.
MAINTENANCE AND STORAGE
The owner/operator is responsible for all periodic maintenance.
WARNING:
Never operate a damaged or defective generator.
WARNING
: Tampering with the factory set governor will void your warranty.
WARNING
: Improper maintenance will void your warranty.
NOTE:
Maintenance, replacement, or repair of emission control devices and systems may be
performed by any non-road engine repair establishment or individual.
Complete all scheduled maintenance in a timely manner. Correct any issue before operating the
generator.
Engine Maintenance
To prevent accidental starting, remove and ground spark plug wire before performing any service.
Oil
Change oil when the engine is warm. Refer to the oil specification to select the proper grade of oil for
your operating environment.
1. Remove oil fill cap/dipstick.
2. Use pliers to slide the spring clamp down the oil drain hose and pull the hose off the plug bracket.
3. Point the hose into a drain pan and allow the oil to drain completely. Note: The hose end must be
lower than the engine base to allow the oil to drain.
4. Replace oil drain hose onto plug bracket and slide spring clamp back into position.
5. Add 0.6Lof oil and replace oil fill cap/dipstick. DO NOT OVERFILL.
6. Dispose of used oil at an approved waste management facility.
NOTE:
Once oil has been added, a visual check should show oil about 1-2 threads from running out of the fill
hole. If using the dipstick to check oil level, DO NOT screw in the dipstick while checking.
Spark Plugs
1. Remove the spark plug cable from the spark plug.
2. Use the spark plug tool that shipped with your generator to remove the plug.
3. Inspect the electrode on the plug. It must be clean and not worn to produce the spark required for
ignition.
4. Make certain the spark plug gap is 0.7 - 0.8 mm or (0.028 - 0.031 in.).
5. Refer to the spark plug recommendation chart when replacing the plug.
