ORIGINAL INSTRUCTIONS > EN
10
3. ASSEMBLY
Your generator requires some assembly. This unit is shipped from our factory without oil. It must be
properly serviced with fuel and oil before operation.
Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Using the carrying handles of the unit, carefully remove the generator from the box (two people lifting
is recommended)
Add Engine Oil
CAUTION
: DO NOT attempt to crank or start the engine before it has been properly filled with the
recommended type and amount of oil. Damage to the generator as a result of failure to follow these
instructions will void your warranty.
NOTE
:
Recommended oil type is 10W-30 automotive oil.
1. Place the generator on a flat, level surface.
2. Loose the cover screw and remove the maintenance cover
3. Remove oil fill cap/dipstick to add oil.
4. Add 0.6L of oil and replace oil fill cap/dipstick.
DO NOT OVERFILL.
5. Check engine oil level daily and add as needed.
NOTE:
Once oil has been added, a visual check should show oil about 1-2 threads from running out of the fill
hole. If using the dipstick to check oil level, DO NOT screw in the dipstick while checking?
NOTE:
Check oil often during the break-in period. Refer to the Maintenance section for recommended service
intervals.
CAUTION:
The engine is equipped with a low oil shut-off and will stop when the oil level in the crankcase falls
below the threshold level.
