Feider Machines FDL125, Owner'S Manual

Page: 13 / 25

being cut.
c) In the thin materials first feed the blades down with the teeth protruding only 10 -12mm, then
move forward (or backward) for cutting. see picture at page 12.
d) If the feed speed is too slow…
The blades will only press down the material rather than cutting it.
The blade edges glides and wears down the material.
This will cause a poor cut and will cause excessive wear on the blades.
e) If the feed speed is too fast...
This will cause overload, Short time overload is allowed, but do not always have the machine
running at overload status.
This will cause the blade teeth excessive wear and teeth break, result in shortening the blades
life cycle.
This will cause a definite risk that the cut might split. The splinter will get bigger and bigger and
eventually break risking serious personal injury.
f) The suggested feed speed...
The suggested speed for cutting any material, please just follow the blades moving while
cutting, and control the cutting power between 0.8 to 1.2 rated power.
SWITCH ON AND OFF
To start the machine, first push the Switch lock button and then press the Switch Trigger and keep
it pressed (Please see the picture below).
To switch off the machine, release the Switch Trigger.
Note: For safety reasons, the Switch Trigger cannot be locked; it must remain pressed during the
entire operation.
13