39
5) Place the cap in the waste tank, and move the carriage back to home. (Figure 5-5)
6) Close the cover of waste tank. Finish the daily maintenance. (Figure 5-6)
5.5 Short term shut down (3~7 days)
1
）
Disconnect the tube connector for the tube from the Subtank to the printhead. Wait
until the ink finishes dropping, and then, connect the tube to the solvent tube. Press
both of the flush buttons to clean the printhead with solvent. Stop until the solvent
becomes clear nearly.
2
）
Use tube cover to seal the ink incoming tube for the printhead. Use fresh wrap to cover
the nozzle surface. Then, push the carriage all the way to the left to seal printheads by
the cap.
5.6 Long term shut down (More than a week)
1
）
Clean the whole ink supply system by solvent.
2
）
Disconnect the tube connector for the tube from the Subtank to the printhead. Wait
until the solvent finishes dropping almost. Use tube cover to seal the ink incoming
tube for the printhead. Use fresh wrap to cover the nozzle surface. Then, push the
carriage all the way to the left to seal printheads by the cap.
Attention
：
For keeping the ink supply system clean, please replace the filter every 4
months.
Figure5-5
Figure5-6
Chapter
5
Maintenance
Guide
