35
3.1 Printing Mode
There are two options for unidirection and bidirection.
3.2 X Direction Mode
This is an option which is used for adjusting printheads alignment. It is recommended
that the printheads alignment is adjusted under 180DDPI after installing printheads. For
printing pictures of other resolutions, first choose the corresponding resolution under “X
Direction Mode”, then click “Auto Adjust by 180DPI” and “Save Parameters” under
“Uni-color” and “Head Adjustment”. The software will automatically create the
corresponding adjusting parameters for printing. During actual printing, the adjusting
parameters probably need to be adjusted tinily again.
Remark: The option is only available for adjusting printhead alignment. For printing
pictures, it is unnecessary to choose the corresponding resolution due to the software can
automatically get the corresponding adjusting parameters for printing.
3.3 Printhead Nozzle Select
“Start” aims at the direction of feeding forward; “End” aims at the direction of feeding
backward. The value (0-7) means the number of nozzles which will be unavailable for
firing ink while the nozzles status at the two sides of printhead is not satisfied.
3.4 Media Movement after Printing
This is an option which is used for setting the movement direction and distance(mm) of
media after completing print.
3.5 Flash Jetting Setting
There are three options, 1) (Home) Frequency(Hz): The setup for flash jetting frequency
at home with no printing ( The changed flash jetting frequency will be activated after doing
the operation of “Save Parameters” and “Home”). 2) (Clean) Frequency(Hz): The setup for
flash jetting frequency at home during printing. 3) Num of Time(s): The setup of flash
jetting time.
3.6 Cleaning Option
There are Two options, 1) No Cleaning and 2)Flash Jetting Cleaning. The “Flash Jetting
Frequency” in 3.5 will be activated after choosing the “Flash Jetting Cleaning”. The “Pass”
can be set between 0-255Pass.
3.7 Color Bar Setting
1) Pos: Setup for no color bar, or the position of color bar (in the right/left/both side of
the picture). 2) Width (mm): Setup for the width of the whole color bars. 3) Distance (mm):
Setup for distance between the color bar and the picture.
Chapter
4
Basic
Operation
