Fei Bao Velox, Assembly Manual, Page: 34 / 64

F E I B A O V E L O X
34 34 34 34
110. Epoxy those blocks into place, level with the existing mounts. Do not
epoxy them to the mounts, but only to the wings and to the little corner
triangular blocks that hold the servo cover hold-down screws.
111. When the new blocks are thoroughly dry, cut away the old ones. A
few strokes of a sharp exacto will do it.
112. Trim the blocks for your servo. Make a cutout for the servo lead.
113. Install the flap servo as shown, along with the linkage and horn. Note
that they may not be much structure beneath this new slot to hold the
horn, pay extra attention to using lots of Hysol glue when you glue this