F E I B A O V E L O X
33
33
33
33
the cover into place.
107. Fit the linkage, control horn, and slot for the control horn as you did
for the rudders. Again, you can wait till later to glue the horns.
108. The flap and aileron servos go in the same way as the elevator
servos, with some notes. You will need 12" extensions on the aileron
servos. The flap servos, of course, only travel down, so adjust your
linkages and servos accordingly, so that they are all the way at one end
when the flaps are up(neutral, level with the wing), and all the way at the
other end when flaps are down. Note that you will need a servo
reverser, a JR Matchbox, a reversed servo, or two separate channels for
normal setup of the flaps, or one will work backwards. If you are using
the popular Spektrum DX7 radio, you will not have a spare channel to
program the second flap to move correctly. Here is a trick to allow you to
run both flap servos off one channel with just a regular servo y-harness.
109. Install the flap servo into the right wing normally. For the left wing, do
this: Cut two scrap plywood blocks as shown, the same width as the
existing servo mounts, but about 1" long.
Summary of Contents for Velox
Page 64: ...64 64 64 64...
