E3980 VRSS
10
LAG BOLT
LOCATIONS
Once all the bolts are removed, slide the unit off the back of the shipping pallet, and tilt it
so the rear corner touches the ground. Then have someone move pallet out from under
the case and gently tilt the case forward until it touches the floor.
REMOVE CASE OFF OF FRONT OR BACK OF SKID ONLY
PULL SKID AWAY FROM CASE
AND GENTLY SET CASE ON FLOOR
Removing Packaging Material
Remove bubble wrap and packing material for all shelves and panel, brackets, etc.
If it is necessary to remove tape residue from plastic materials, use cleaning
compounds recommended in the cleaning section of this manual.
Lifting and Moving the Case
Caution:
Do not push or pull against the glass air deflector on front of
case. Doing so can cause the glass to break. Do not push or pull
on side glass or pull on base panel. Doing so will break glass or
pull out panel mounting screws. Care must be taken not to
damage the case when removing it from the skid or moving the
case.
