E3980 VRSS
9
(7)
INSTALLATION INSTRUCTIONS
7.1
LOCATING THE DISPLAY CASE
The case(s) should be located where it is not subjected to the direct rays of the sun,
heating ducts, grills, radiator, or ceiling fans, nor should it be located near open doors or
main door entrances. Also, avoid locations where there is excessive air movement or
air disturbances and avoid high humidity locations such as near cases with water
misting or fogging devices. Failure to locate this case as stated will reduce the
performance of your display and will affect temperature of interior of case and product.
If this case or cases are to be located against a wall there should be at
least 6” between
the case and the wall to allow air circulation. Failure to give adequate space may cause
exterior surfaces to sweat.
7.2
REMOVING CASE FROM SHIPPING SKID
Be sure to leave shelf packaging material intact for this step.
First remove the base front and rear panels
REMOVE FRONT PANEL SCREW
THEN LIFT UP
ROTATE BOTTOM OF PANEL FORWARD
AND SLIDE OUT FROM BEHIND VALENCE
Two or more people should be involved in moving the unit from the pallet onto the
ground.
Remove the (4
) 1/4” screws that secure the case to the skid. These screws are located
in the front and rear corners of the base rails. Base front and rear panels must be
removed to access these bolts.
