E3981 VHSS
7
(5)
INSTALLATION INSTRUCTIONS
5.1
LOCATING THE DISPLAY CASE
The case(s) should be located where it is not subjected to the direct rays of the sun, heating
ducts, grills, radiator, or ceiling fans, nor should it be located near open doors or main door
entrances. Also, avoid locations where there is excessive air movement or air disturbances and
avoid high humidity locations such as near cases with water misting or fogging devices. Failure
to locate this case as stated will reduce the performance of your display and will affect
temperature of interior of case and product.
5.2
REMOVING CASE FROM SHIPPING SKID
Be sure to leave shelf packaging material intact for this step.
First remove the base front and rear panels
Two or more people should be involved in moving the unit from the pallet onto the ground.
Remove the (4
) 1/4” screws that secure the case to the skid. These screws are located in the
front and rear corners of the base rails. Base front and rear panels must be removed to access
these bolts.
LAG BOLT
LOCATIONS
Once all the bolts are removed, slide the unit off the back of the shipping pallet, and tilt it so the
rear corner touches the ground. Then have someone move pallet out from under the case and
gently tilt the case forward until it touches the floor.
