E3981 VHSS
11
JOINING TRIM
6.
Replace all panels that were previously removed.
6.1.2
Join units with glass divider, or join heated to non-refrigerated
For this joining configuration, one unit will come with a lower end panel preinstalled with
glass. Five bolt holes will be exposed on the outside of this panel and are the locations that
will be used to join the units together. This kit also comes with top and rear exterior trim,
but no interior trim.
1. Remove all Shelves, display deck, interior back panel(s), exterior back(s), front and rear
base panel, and loosen honeycomb (see cleaning section for honeycomb removal)
material on the unfinished end to expose the holes used to bolt units together.
2. Position the right or left most unit in the desired position for the lineup to start, and level
this case.
3. Push the 2
nd
case next to the 1
st
and line them up as closely as possible.
4. Adjust the leveling legs of the 2
nd
case until the bolt holes align with the mating holes in the
joining case.
5. Push the units together so that the through bolts go through the case to be joined.
6. Using the hardware provided (1/4-20 screw, washer, lock washer), screw the 2
nd
case with
the unfinished end into the first case.
