1-4
RAD
PA
WAIL
YELP
H/L
PRTY
MAN
A/H
17
18
19
20
RESET
2
3
5
6
7
8
1 - Mode 1 (pattern #43)
2 - Mode 2 (pattern #26)
3 - Mode 3 (pattern #27)
4 - Reset
5 - SignalMaster "step through"
6 - Takedown (pods 3 & 5)
7 - Flash (pattern #46) &
Relay A (push-on/push-off)
8 - Rear Osc. (pattern #42)
9 - Radio rebroadcast
10 - Public address
11 - Wail
12 - Yelp
13 - Hi-Lo
14 - Priority
15 - Manual
16 - Air Horn
17 - Jog Left (pattern #86)
18 - Left Alley (pod 3 - pattern #76)
19 - Right Alley (pod 5 - pattern #73)
20 - Jog Right (pattern #87)
Horn Ring Transfer - pattern #32
1
OFF
Figure 1-1. Keyboard Configuration 2.
ANY changes to the described keyboard configura-
tion. It is YOUR responsibility to understand how
this system is configured (programmed) to operate.
NOTE
Keyboard Configuration 2 (preselected at the
factory) is referred to as the default keyboard
configuration .
A.
Keyboard Configuration 2 (POLICE ).
NOTE
Refer to figure 1-1 while reading paragraph
1-7.A.
1.
Slide Switch Position 1 (MODE 1).
Slide switch position activates Mode 1.
In this keyboard configuration; the center light
rotates at 90 FPM and a four-light, alternating,
oscillating pattern to the rear is activated. The LED’s
in the V-shaped display will flash simulating, but not
necessarily indicating, the lights are activated and
the slide switch position 1 LED illuminates. Return
the slide switch to OFF to deactivate Mode 1. The
LED’s in the V-shaped display and the slide switch
position 1 LED will extinguish.
2.
Slide Switch Position 2 (MODE 2).
Slide switch position 2 activates Mode
2. In this keyboard configuration, four lights rotate at
90 FPM and three lights oscillate to the front. The
wail siren tone will sound. The LED’s in the V-
shaped display will flash simulating, but not neces-
sarily indicating, the lights are activated and the
slide switch position 2 LED will illuminate. Return
the slide switch to OFF to deactivate Mode 2. The
LED’s in the V-shaped display and the slide switch
position 2 LED will extinguish. The wail siren tone
will silence.
3.
Slide Switch Position 3 (MODE 3).
Slide switch position 3 activates Mode
3. In this keyboard configuration, all seven lights
rotate in synchronization at 90 FPM creating a
center-out pattern. The wail siren tone will sound.
The LED’s in the V-shaped display will flash simulat-
ing, but not necessarily indicating, the lights are
activated and the slide switch position 3 LED will
illuminate. Return the slide switch to OFF to deacti-
vate Mode 3. The LED’s in the V-shaped display and
the slide switch position 3 LED will extinguish. The
wail siren tone will silence.
4.
Switch 4 (RESET).
Press this switch to extinguish all
lights (if activated) in the lightbar. The RESET LED
will illuminate and the reflectors rotate to the “home”
position. All other LED’s will extinguish and acti-
vated functions will deactivate.
NOTE
The RESET switch may be pressed at any
time to deactivate any previously selected
function(s). If a slide switch function is acti-
vated when the RESET switch is pressed, all
activated lights in the lightbar momentarily
extinguish. Then the slide switch selected
function reactivates.
5.
Switch 5 (SignalMaster).
NOTE
This switch may be labeled “LRC-O” indicat-
ing—Left, Right, Center out, and Off.
Pressing this switch controls the
SignalMaster directional signal (if installed). It
provides a flashing arrow signal directing traffic to
move to the left, right, or around both sides of the
vehicle. In this keyboard configuration, the
SignalMaster switch utilizes “step through” activa-
tion. Each press of switch 5 steps through the
various directional signals.
Switch 5 LED illuminates when the
SignalMaster is activated. Also, the row of LED’s
under the V-shaped display simulates, but does not
necessarily indicate, the light pattern being executed
by the directional signal.
a.
Press switch 5 to activate a left
arrow directional signal.
b.
Press switch 5 a second time to
activate a right arrow signal.
c.
Press switch 5 a third time to
activate a center out signal.
