5. Concealed Conduit Mounting.
Refer to the introduction, warning message to installers, and basic installation instructions
above before installing horn.
The concealed conduit mounting method may be useful when an existing junction box will not
accommodate the basic installation. This installation configuration requires the use of a Model NB
Knockout Box and a Model CC Adapter Plate. Use the pair of 6-32 or 8-32 flat head screws to
mount the plate on the existing box. Install the insulated bushing in the rear of the knockout box
before attaching the box to the adapter plate with two 10-32 x 1/4" round head screws. The
insulated bushing protects the power leads that pass through the center hole in the CC Adapter
Plate and the center knockout of the WB box to the horn. (Diagram G).
6. PR Projector Installation.
Refer to the introduction, warning message to installers, and basic installation instructions above before
installing horn.
The Model PR Projector can be added to any of the installations described on this sheet. Secure
the projector to the horn with the two 10-32 x 1/2" Phillips head Taptite screws provided in the
accessory kit. Use two additional 8-32 slotted head screws (provided) in the remaining mounting
holes of the projector. If it is desired to use either of the projectors when the horn is flush
mounted, it is necessary to install the Model SF Plate instead of the FG Grille. (Diagram H).
7. PR2 Projector Installation.
Refer to the introduction, warning message to installers, and basic installation instructions above before
installing horn.
The Model PR2 Projector can be added to any of the installations described on this sheet. Secure
the projector to the horn with the two 10-32 x 1/2" Phillips head Taptite screws provided in the
accessory kit. Use two additional 8-32 slotted head screws (provided) in the remaining mounting
holes of the projector. If it is desired to use either of the projectors when the horn is flush
mounted, it is necessary to install the Model SF Plate instead of the FG Grille. (Diagram I).
8. Weatherproof Panel Mounting.
Refer to the introduction, warning message to installers, and basic installation instructions above before
installing horn.
The Model TR trim ring can be installed with the horn for panel mounting applications requiring
Type 4X Rating. Center the trim ring between the panel and the horn. Secure the assembly to the
panel using the (4) 8-32 x 1-5/8" screws, screw collars, and keps nuts (Diagram J).
NOTE
Only the hardware supplied with the Model TR should be used to ensure the Type 4X Rating.
9. Optional Weatherproof Panel Mounting Kit.
When mounting the horn in a panel application requiring a NEMA 4X Rating, purchase Kit No.
8435666. This weatherproof mounting kit includes a gasket and hardware for flush mounting
(Diagram K) the horn.
-3-
